Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
14 Prior to initial commissioning
14.1 Commissioning the mobile terminal
Please ensure that the battery inserted in the mobile terminal at the factory is fully charged before initial
commissioning. Connect the docking station to the mains using the provided power supply unit and insert the
mobile terminal into the docking station (if included in the scope of delivery).
The battery charging process has been completed when the charge LED shows a green light.
You can now use the mobile terminal.
Further information on the mobile terminal and the docking station is available in the following chapters.
14.2 Commissioning the docking station
Place the docking station on a flat, sturdy and clean surface away from direct sunlight. Insert the power cable
into the external power supply unit. Insert the DC plug of the power supply unit into the DC socket at the rear
of the docking station (labelled with the DC symbol
The docking station is disconnected from the mains by pulling the
mains plug.
The corresponding power socket must be located near the docking
station and it must be easily accessible.
NOTE
15 Handling of the mobile terminal and the docking station
15.1 Mobile terminal
15.1.1 Switching on
Please use the following buttons in order to switch the mobile terminal on:
Rapid-entry keyboard: „C" + „orange Enter" button
Silicone keyboard:
The status LED turns green as soon as the mobile terminal is switched on. The desktop of the operating
system or your usual work environment appears on the display.
15.1.2 Switching off
Please use the following buttons in order to switch the mobile terminal off:
Rapid-entry keyboard: „C" + „" + „orange Enter" button (held for 10 seconds).
Silicone keyboard:
The status LED goes out as soon as the mobile terminal is switched off.
M160_Set_Kurzübersicht_Brief Overview_V1.04_de_en
Power button.
Power button (held for 10 seconds).
).
20 / 29
Werbung
Inhaltsverzeichnis
