Setting Into Operation; Specifications - Monacor TM-17 Bedienungsanleitung

4 Setting into Operation

The megaphone can either be operated with
batteries or be supplied with power externally,
e . g . via the 12 V electrical system of a car or
a 12 V power supply unit . When an external
power supply is connected, the inserted batter-
ies will be switched off .
4.1 Inserting Batteries
1) Unlock the latch (4) and open the battery
compartment cover (8) .
2) Insert eight 1 .5 V batteries of C size into the
battery compartment . Observe the correct
polarity (see imprint in the battery compart-
ment) .
3) Close the battery compartment; fold the
cover (8) upwards and lock it with the latch .
If the unit is not used for a longer period (e . g .
more than a week), remove the batteries as a
precaution so that the unit will not be damaged
in case the batteries should leak .
Do not put discharged batteries or de-
fective rechargeable batteries into the
household waste; always take them to
a special waste disposal (e . g . collection
container at your retailer) .
4.2 External power supply
For connection to the power supply jack DC
12 V (7), a low-voltage plug ⌀ 2 .1/ 5 .5 mm
(inside / outside diameter) with positive polarity
at the inside contact is required . A connection
cable with a plug for the socket of the electrical
system of a car (cigarette lighter socket, cen-
tre contact positive) is supplied with the meg-
aphone . When using the cigarette lighter socket,
make sure to remove any ashes to ensure good
electrical contact . If necessary, clean the socket
with a soft, dry cloth .
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
5 Operation
1) For talking, set the switch (9) to the position
SPEAK . The microphone can be hand-held
or put onto the hook on the rear side of the
megaphone . Talk into the front side of the
microphone (2) while keeping one of the two
talk switches (1) pressed . The switch at the
hand-held microphone can be engaged by
sliding it in the direction of the arrow . Then
the microphone will remain switched on . Hold
the microphone as close to your mouth as
possible .
2) Adjust the desired volume with the control
(3) . In case of howlback, turn back the control
accordingly .
3) To switch on the siren or the whistling sound,
set the switch (9) to the position SIREN or
WHISTLE and press one of talk switches (1) .

6 Specifications

Amplifier power: . . . . . . . . 25 W max .
Medium sound pressure: . 110 dB
Power supply: . . . . . . . . . 8 × 1 .5 V battery
Dimensions: . . . . . . . . . . . ⌀ 230 mm ×
Weight: . . . . . . . . . . . . . . 1,5 kg
Subject to technical modification .
of C size or
⎓ 12 V externally,
2 A
340 mm
7