First-Time Configuration - Conceptronic CM3G Benutzerhandbuch

ENGLISH
The unit needs to be configured when you turn it on the first time.
• Select the correct input channel on your TV where the unit is connected to. (HDMI, Composite, SCART,
S-Video or Component).
Note: From this point, the manual is based on the fact that your TV is set to the input channel of the
unit. All steps described are related to the operation of the unit.
• Check if the main power switch on the back of the unit is set to 'I' (On).
• Turn on the unit with the power button on the front of the unit, or with the 'Power' button (1) on the
remote control.
• Check the Power LED on the front of the Media Giant. When the LED is Orange, the device is in
'Standby' mode. When the LED is Blue, the device is operational.
Note: The unit needs to be initialized when it is turned on. This can take a little while. During
initializing, the Media Giant startup screen is shown.
[ Startup Screen ]
When the Media Giant is initialized, it needs to be configured for first time usage. To assist you with the
first time configuration, the Media Giant will display the 'Setup Wizard' on your screen with the required
configuration steps for first time usage.
The Setup Wizard will display the following configuration steps:
- menu Language
- TV Signal **
- Channel Scan **
- Network Setup
- Set Time
Use the navigation keys and the 'Enter' button (28) on the remote control to setup your Media Giant.
If you made a setting and you want to revise it, press the 'Return' button (7) on the remote control.
Menu Language
Select the language you want to use when operating the Media Giant.
TV Input **
Select your country from the country-list. If your country is not listed, select 'Don't Care' from the list.

7. First-Time Configuration

44
[ Setup Wizard ]