Allen-Bradley PanelView 300 Installationsanleitung Seite 9

4. Install the 4 self-locking nuts, hand tight.
5. Alternately tighten the self-locking nuts until the terminal is held firmly
against the panel. Tighten the nuts to a torque of 10 inch-pounds. Do not
overtighten.
ATTENTION
!
Mounting nuts must be tightened to a torque of 10
inch-pounds to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal
or other equipment within the enclosure because of
improper installation.
PanelView 300 Micro Terminal
Self-Locking Nuts
(4 used, 6 provided)
9
41061-156-01(A)