Installing Terminal In Panel - Allen-Bradley PanelView 300 Installationsanleitung

8 PanelView 300 Micro Terminal

Installing Terminal in Panel

Other than the tools required to make the panel cutout, the tools required for
installation are:
• 7 mm (M4) deep well socket wrench or nut driver
• small slotted screwdriver
• torque wrench (in. / lbs.)
To install the PV300 Micro in a panel:
ATTENTION
!
1. Cut an opening in the panel using the panel cutout provided with the terminal.
Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as shown
below). This gasket forms a compression type seal. Do not use sealing
compounds.
3. Place the terminal in the panel cutout.
41061-156-01(A)
• Disconnect all electrical power from the panel before
making cutout.
• Make sure area around the panel cutout is clear.
• Take precautions so that metal cuttings do not enter any
components already installed in panel.
• Failure to follow this warning may result in personal injury
or damage to the panel components.
Sealing Gasket