Allen-Bradley PanelView 300 Installationsanleitung Seite 12

12 PanelView 300 Micro Terminal
3. Gently push the blade of the screw driver away from the terminal block to
release locking mechanism.
4. Remove DC power terminal block.
To re-install the DC power terminal block
Note: Install the terminal block with or without the power wires connected.
1. Disconnect all electrical power from the panel prior to installation. See
Explosion Hazard Warning on previous page.
2. Position the terminal block at a 45
edge of the wire connection side into the base.
3. Gently push the top of the terminal block back to a vertical position to snap in
the locking tab.
Press terminal block
base in first with
block leaning outward
Push top back to
vertical position
to lock-in.
41061-156-01(A)
Insert tip of screw driver here.
°
angle to the base surface and place lower