Allen-Bradley PanelView 300 Installationsanleitung Seite 11

To connect DC power to the PanelView 300 Micro terminal:
1. Secure the DC power wires to the screw terminal block.
2. Secure the Functional Earth Ground wire to the screw terminal block.
DANGER
!
3. Apply power (24V dc nominal) to the terminal.
+
DC Positive
-
DC Negative
Functional Earth Ground
Removing and Installing the Power Terminal Block
You can remove and re-install the power terminal block for ease of installation,
wiring and maintenance. The terminal block is pre-installed when shipped.
Additional terminal blocks (quantity of 10) are available by ordering Catalog
Number 2711-TBDC.
To remove the DC power terminal block:
1. Disconnect all electrical power from the panel. See Explosion Hazard Warning
above.
2. Insert tip of small flat-blade screw driver into DC power terminal access slot.
Explosion Hazard
• Substitution of components may impair suitability for Class
I, Division 2.
• Do not disconnect equipment unless power has been
switched off and area is known to be non-hazardous.
• Do not connect or disconnect components unless power has
been switched off.
• All wiring must comply with N.E.C. article 501-4(b).
PanelView 300 Micro Terminal 11
41061-156-01(A)