AEG A61900HLW0 Benutzerinformation Seite 27

Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Products are not wrapped
properly.
Temperature is set incorrect-
ly.
The lid is not shut properly
or do not close tightly.
This is normal, no error has
occurred.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The products' temperature
is too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FROSTMATIC function
is switched on.
ENGLISH
Solution
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the products better.
Refer to "Operation" chap-
ter.
Check if the lid closes well
and the gaskets are undam-
aged and clean.
The compressor starts after a
period of time.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
27