Prior To The Initial Commissioning Of The M260Se; Handling Of The Device; Charging The Power Supply Unit For The Ds260 & M260Se; Implementing Ds260 - ACD DS260 Kurzübersicht

The M260SE battery is a lithium polymer battery pack. Lithium
polymer battery packs can explode if exposed to fire. Do not
disassemble the battery pack and do not expose it to fire or heat
ATTENTION
(greater than 60°C).
Only operate the touchscreen using the fingertips or with the
touch-pen attached to the retainer strap on the rear. Never use a
pen or other sharp objects.
ATTENTION
Never position the device in close proximity to heat sources
(heating fans or similar equipment) and never expose it to direct
sunlight, excessive dust sources or shocks.
ATTENTION

12 Prior to the initial commissioning of the M260SE

In order to ensure that the battery inserted into the device at the factory is fully charged, insert the device into
the supplied DS260 docking station (if included in the scope of delivery), also see Point 13.4. Using the
supplied power supply unit, connect the docking station to the mains (Power LED shows a green light).
The battery charging process has been complete when the "CHARGE" LED shows a green light. You can
now use the M260SE handheld terminal.

13 Handling of the device

13.1 Charging the power supply unit for the DS260 & M260SE

The M260SE and the spare battery may only be charged in the DS260 docking station with respective
power supply unit.

External power supply unit for DS260

Input voltage ~ 100 - 240V AC; 0,8A; 50 - 60 Hz

Output voltage

ACD approved power supply: Adapter Tech. STD-15026

Power cable (country-specific)

13.2 Implementing DS260

Put the docking station DS260 on a flat, stable, clean, not-sunny place. Insert the power cable into the
external power supply. Insert the direct current connector into the current connector jack on the back of the
DS260 (on the left, marked with

The docking station DS260 will be separated from supply voltage by
unplugging the power plug. The corresponding socket should be
placed near by the DS260 and easily accessible.
NOTE

13.3 Replacing the battery in the M260SE handheld terminal

The battery compartment is located on the rear of the device. In order to remove the battery, first remove the
transverse hand strap by simply unhooking it. Now push the locking tab on the battery towards the battery
surface (see Fig. 6). The battery can now be removed from the tab.
The battery can easily be inserted. In doing so, ensure that you insert the battery at a slight incline towards
the contacts and hook it on the fixing tab whilst doing so. Then close the locking mechanism with a slight
amount of pressure.
M260SE_Set_Kurzübersicht_V1 12_de_en.docx
15V DC; 2,4A
).
10 / 16