Replacement Of Batteries; Location Of The Remote Controller - Olimpia splendid CALDO CRYSTAL Installations, Bedienungs And Wartungsanweisungen

7.3 - Replacement of batteries

The batteries should be replaced when the display on the remote control does not
appear sharply or when the remote control does not change the settings.
When the batteries have been replaced, adjust the remote control clock.
• If the remote control is not used for several weeks or longer, remove the batteries.
Any leaks from the batteries could damage the remote control.
• The average life-span of the batteries, with normal use, is approx. six months.
Replace the batteries when the indoor unit command receipt "beep" can no longer
be heard, or if the transmission indicator on the remote control does not switch on.
Always use new batteries and replace both at the same time.
The use of old or different batteries could generate malfunctioning
of the remote control.
• When replacing batteries, replace both and dispose of the dead
batteries in the appropriate collection centres and as required
by law.
• Do not re-charge or disassemble the batteries. Do not throw the
batteries into the fire. They can burn and explode.
• If the battery liquid falls onto the skin or clothes, wash well with
clean water. Do not use the remote control with batteries that
have leaked.
The chemical products contained in the batteries can cause
burns or other risks to health.

7.3 - Location of the remote controller

• Keep the remote control in a position from which the signal can reach the indoor unit
receiver (max. distance approx. 8 metres - with the batteries charged) (figure H).
The presence of obstacles (furniture, curtains, walls, etc.) between the remote
control and the appliance reduces the remote control working range.
EN - 13
CALDO CRYSTAL