Switching Via Step Keys; Switching By Mouse - G&D TradeSwitch2-USB Installation Und Bedienung

Switching

Switching via step keys

IMPORTANT: Step keys are deactivated in the default settings. Information on how
to enable this function are provided on page 24.
Alternative to using select keys to switch between channels connected to the KVM
switch is to use the step keys to switch the channels in ascending or descending order.
IMPORTANT:
The active step keys depend on the selected select keys. The following
table lists the step keys depending on the active select keys.
Select keys
1 ... 2
NUM 1 ... 2
A ... B
F1 ... F2
How to use step keys to switch to a certain channel:
1. Press
Hotkey+»Back« step key
console keyboard.

Switching by mouse

IMPORTANT: Switching by mouse is deactivated in the defaults of the KVM switch.
Information on activating the function is given on page 28.
How to access the active channel by mouse:
 Press and hold the mouse key
 Move the mouse to the left or the right to switch between the channels in ascen-
ding or descending order.
The TradeSwitch-LEDs shows the currently active channel.
NOTE: If the
Single
nel in ascending or descending order.
The mode allows you to access several channels.
Multiple
9 · G&D TradeSwitch2-USB
»Back« step key
9
NUM 9
I
F9
or
Hotkey+»Forward« step key
4 (usually:
mode is activated, you can access the previous or the next chan-
»Forward« step key
0
NUM 0
K
F10
on the
Back ).