Maintain For Performance; Storing; Troubleshooting/Repairs - Max CN890S Betriebsanleitung

5. MAINTAIN FOR PERFORMANCE

q DO NOT FIRE THE NAILER WHEN IT IS EMPTY
w USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the moisture and dirt inside compressor to pass into the tool
directly. This causes rust and wear, and results in a poor operating performance. The hose length
between airset and tool should be no longer than 5 m since a longer length results in a reduction in air
pressure.
e USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon completion of operations, place 2
or 3 drops of oil into the air plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
r INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
WARNING:
Disconnect air supply and empty the magazine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly

6. STORING

q When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid
rust.
w Do not store the tool in a cold weather environment. Keep the tool in a warm area.
e When not in use, the tool should be stored in a warm and dry place. Keep out of reach of children.
r All quality tools will eventually require servicing or replacement of parts because of wear from the
normal use.
7. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO., LTD. authorised distributors
or by other specialists.
Supplement to the operating instruction
According to the European Norm EN 792-13 the regulation is valid from 01.01.2001 that all fastener
driving tools with contact actuation must be marked with the symbol "Do not use on scaffoldings,
ladders" and they shall not be used for specific application for example:
＊ when changing one driving location to another involves the use of scaffoldings, stairs, ladders or
ladder alike constructions e.g. roof laths,
＊ closing boxes or crates,
＊ fitting transportation safety systems e.g. on vehicles and wagons.
14