Herunterladen Inhalt Inhalt Diese Seite drucken

NINCOAIR NH92007 RTF Bedienungsanleitung Seite 14

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
NH92007 RTF – NH92008 ARF GLIDER PRO
10. FLYING INSTRUCTION
1. Take off.
This plane needs to be taken off by hand-launch. Move the throttle stick fully forward slowly, the motor
will be started slowly till turning at the maximum speed; ask a friend launches the plane against wind
at an elevation angle of 15º for you. You may add a little gentle up the elevator trim till it gets a safe
height (more than 30m). Then you could try to move the rudder stick to turn the airplane. But you
must be aware of moving all control inputs slowly and gently.
WIND
2. Flying.
Beginners should practice flying on a calm day. Practice the control of elevation and turning after
gaining the height of 30-100m. Once it climbs up to 100m high, you will get enough safe altitude for
trying the loop, invert and glide the plane. Stop the practice when it is below 30m.
The elevator control stick is for controlling elevation of the plane. Move the stick forward, the elevator
on the plane will move downward and the plane will descend. Move the control stick upward, the
elevator will move upward and the plane will climb up, too much up control will cause the airplane
'stall' and drop from the sky, therefore always move the control stick gently to avoid the accident.
After becoming proficient in controlling the elevator and ailerons, you can try to practise the basic and
advance flight as cuba-8, loop, invert...
The continuous power time is about 6 minutes. Land the plane if it climbs up slowly or descends when
you move the throttle stick fully forward. The propeller may slow down or stop if the power of the
battery is not enough. The power system will remain rest power is for the servos to land the model.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
14

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Glider proNh92008 arf

Inhaltsverzeichnis