Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
Before turning on the transmitter, make sure the throttle stick is pulled all
the way back. Switch on the transmitter. The green and red LED should
be iluminated. WHEN THE RED LED ONLY IS ILUMINATED, THE
BATTERIES MUST BE REPLACED IMMEDIATELY. DO NOT FLY WITH ONLY
THE RED LIGHT ILUMINATED.

2. CHARGING THE BATTERY

Do not charge the battery more than 120 minutes.
Before the first flight, the battery should be circled 3-4 times to 'wake' it up for its best flight
performance. Please, follow the charge instruction that follow in order to charge the flight battery:
DC12v power source
Charging steps.
1. Use only included 'Li-po' charger against the warranty may cause danger. Connect the charger to DC
12V wall adapter and the battery as shown. You can charge from your car as a DC 12v power source-
Note: the red (+) and black (-) clips must be connected to the correct car battery poles.
2. After connecting the 12v power source properly, the charging LED indicator will turn green.
3. Connect the flight battery to the charging jack on the charger. The LED indicator will blink red,
which indicates the battery is being charged. If the LED stops blinking and remains in green it means
the flight battery pack is fully charged.
4. To charge a fully discharged battery will take about 60 minutes. When the battery is fully charged,
the LED will turn from Red to Green. Disconnect the power source and battery from the charger.
5. After fully charged, the voltage of each single cell of the battery pack should be 4,2 +/- 0.1v.
Therefore the whole battery pack voltage should be 12,3/9v.
6. Do not leave charger unattended while charging. Allow battery to cool down before charging again.
7. Do not store and charge the battery directly under sunlight.
8. Do not charge the battery while the battery is still in the airplane.
Model featured with li-po battery rechargeable, please read carefully these security guidelines:
1. Do not dispose of the battery into fire or heat.
2. Do not use or leave the battery near a heat source, such as fire or a heater.
3. Do not strike the battery or throw it against a hard surface.
4. Do not immerse the battery into water. Keep the battery cool and dry.
5. When recharging the battery, use only the charger designed for that purpose.
6. Do not over-discharge the battery.
7. Do not connect the battery to an electrical outlet.
8. Do not directly solder the battery or pierce it with a nail or other sharp object.
9. Do not transport or store the battery together with metal objects such as necklaces, hairpins, etc.
10. Charge the battery every six months.
11. Turn off your equipment power switch after use.
12. Recycle used batteries after covering the battery terminals with insulation tape or inserting the battery into an individual
polybag.
Connect to flight
battery
Charging indicator
Charge with wall adapter
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
NH92007 RTF – NH92008 ARF GLIDER PRO
10
Charge with car battery

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Glider proNh92008 arf

Inhaltsverzeichnis