Propeller Installation - NINCOAIR NH92007 RTF Bedienungsanleitung

NH92007 RTF – NH92008 ARF GLIDER PRO
5. INSTALLATION OF MAIN WING SET
1. Insert main wing reinforce stick into one half wing.
2. Put stick through fuselage and connect another half wing, before the two half wings fully connected
together with fuselage, aileron servo (under main wing), and fuselage (the part on fuselage where two
half wings join) should be connected first.
3. Connect one end of aileron throttle to the servo arm (outmost hole), and connect another end to
aileron control arm, secure with wrench.

6. PROPELLER INSTALLATION

1. Install propeller on to motor shaft, secure
with nut, see attached picture.
2. Secure the spinner onto propeller adapter
with 2mm x 6 mm screws.
7. FLYING CHECKING
Switch on the transmitter, make sure throttle is
pulled all the way back, other control and trim
part should be place in the middle, plane power
should be the last to switch on.
Before taking off, check to make sure aileron
and main wing, elevator and horizontal
stabilizer, fin and rudder to be paralleled, if n ot,
please adjust connect hole of throttle and arm or by releasing or tightening throttle.
8. BEFORE YOUR FLIGHT
Fly the model when the wind is calm. Pick an open area away from buildings, road or tall trees. Gusty
winds not only make it hard to control your plane but also may cause crash, loss or accident.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
12