Getting Started; Power Supply; Initial Operation - Pce Instruments Pce-Tg 300 Bedienungsanleitung

4

Getting started

4.1

Power supply

To establish power supply, four AA Alkaline batteries are needed. The battery compartment is
located at the rear side of the meter and is affixed with two screws. Loosen the screws, remove the
cover, insert the batteries as illustrated and close the battery cover again by tightening the screws.
4.2

Initial operation

Starting the instrument
To start the meter, press
language can be set by using the F1
To switch off the meter, press and hold
automatically load these when it is switched on again. Even when the batteries are removed, all
settings will remain saved.
System Configuration
The following settings can be found in the sub-menu „System
Configuration".
→ F3 Setup → Main menu
Path:
→
System Configuration
→ F3
Confirm
Function Description
Bluetooth Off / Slave mode / Master mode
Key Sound On / off
Warn Sound On / off
Display brightness setting (0 ... 100 %)
LCD
Brightness
Display Delay time setting
Standby (5 s / 15 s / 30 s / 1 min / 2 min / deactivate)
Auto Power off delay time setting
Poweroff (2 min / 5 min / 10 min / deactivate)
Unit System mm / inch
Date / Time Date and time setting
Set
Language English / German / French / Spanish /Italian
until the display reacts. While the device loads the software, the
key. After loading, the meter will display the main screen.
for 2 seconds. The meter will save all settings and
© PCE Instruments
22