Schumacher PBI1812 Benutzeranleitung Seite 33

2.8 If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT
induce vomiting. Seek medical attention immediately.
3. PREPARING TO USE THE BOOSTER
WARNING WARNING
mouth. Use baking soda and water to neutralize the battery acid and help eliminate
airborne corrosion. Do not touch your eyes, nose or mouth.
3.2 Determine the voltage of the battery by referring to the vehicle owner's manual and
make sure that the output voltage of the booster is correct.
3.3 Make sure that the booster cable clips make tight connections.
4. FOLLOW THESE STEPS WHEN CONNECTING TO A BATTERY
A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE
THE RISK OF A SPARK NEAR THE BATTERY:
4.1
Never allow the output clips to touch each other.
WARNING
4.2
and moving or hot engine parts. NOTE: If it is necessary to close the hood
during the jump starting process, ensure that the hood does not touch the metal
part of the battery clips or cut the insulation of the cables.
4.3 Stay clear of fan blades, belts, pulleys and other parts that can cause injury.
4.4 Determine which post of the battery is grounded (connected) to the chassis. If the
negative post is grounded to the chassis (as in most vehicles), see step 4.5. If the
positive post is grounded to the chassis, see step 4.6.
4.5 For a negative-grounded vehicle, connect the POSITIVE (RED) clip from the booster
to the POSITIVE (POS, P, +) ungrounded post of the battery. Connect the NEGATIVE
(BLACK) clip to the vehicle chassis or engine block away from the battery. Do not
connect the clip to the carburetor, fuel lines or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or engine block.
4.6 For a positive-grounded vehicle, connect the NEGATIVE (BLACK) clip from the booster
to the NEGATIVE (NEG, N, -) ungrounded post of the battery. Connect the POSITIVE
(RED) clip to the vehicle chassis or engine block away from the battery. Do not connect
the clip to the carburetor, fuel lines or sheet-metal body parts. Connect to a heavy gauge
metal part of the frame or engine block.
4.7 When disconnecting the booster, remove the clip from the vehicle chassis, then remove
the clip from the battery terminal, in that order.
5. FEATURES
6
8
WARNING
Attach the output cables to the battery and chassis as indicated below.
Position the DC cables to reduce the risk of damage by the hood, door
2
5 3
RISK OF CONTACT WITH BATTERY ACID.
BATTERY ACID IS A HIGHLY CORROSIVE
SULFURIC ACID.
3.1 Clean the battery terminals before using the
booster. During cleaning, keep airborne corrosion
from coming into contact with your eyes, nose and
9
1. Professional Grade, High Output
AGM Battery
4
2. Charging Status LEDs
3. ON/OFF Switch
4. Internal Battery Status Switch
7
5. Internal Battery Status LEDs
6. 12 Volt DC Power Outlet
7. Heavy Duty, Battery Clips
1
8. Durable Polypropylene Case
9. Clamp Holder
33
• •