Operating Instructions - Herth+Buss Quicky 15A Bedienungsanleitung

Operating Instructions

Battery Type/Mode Button
Set the type of battery to be charged, or Des-
EN
ulfation Mode.
(Calcium) – Calcium batteries are
Ca/Ca
acid batteries impregnated with
calcium.
(Absorbed Glass Mat/Gel) – AGM
AGM/GEL
batteries have electrolyte ab-
sorbed in separators consisting
of a sponge-like mass of matted
glass fiber. Gel batteries contain
gelled electrolytes. These batteries
are sealed with valves and should
not be opened.
(Desulfation Mode) – A special
mode of operation designed for
sulfated batteries.
NOTE: When charging a battery that is not
marked, check the manual of the item which
uses the battery for the correct battery type.
Make sure the battery complies with the
safety instructions in Section 3.3.
www.herthundbuss.com
10. OPERATING INSTRUCTIONS
Battery Information:
This charger can be used with 6 and 12V bat-
teries with rated capacities of 5 Ah to 180 Ah.
Charging:
Ensure that all of the charger components
are in place and in good working condi-
tion, for example, the plastic boots on the
battery clips.
Connect the battery, following the precau-
tions listed in sections 6 and 7.
Connect the AC power following the
precautions listed in section 8.
Select the appropriate settings for your
battery.
IMPORTANT
This charger does not have an ON/OFF
switch. ON and OFF are controlled by
plugging in the charger to the AC wall
outlet. The charger will not supply cur-
rent to the battery clips until a battery
is properly connected. The clips will
not spark if touched together.
Battery Connection Indicator
If the charger does not detect a properly
connected battery, the CONNECTED
not light. Charging will not begin if the CON-
NECTED LED is not on.
95950002
will
28