Voice Guidance; Troubleshooting For Error Codes (Status Display) - Mami Robot pporo Bedienungsanleitung

Voice Guidance

Hello, I'm MamiRobot.
Start charge. When MamiRobot start recharging at the charging station or it is recharged by adapter.
Half an hour / One hour / Continue
Charge the battery, please.
Charging completed.
Damp mop cleaning on.
Check the wheels, please.
Check the battery, please.
Check the sensors, please.
Check the brush, please.
Scheduled cleaning on.
Cancelled. When scheduled cleaning is cancelled.
Finish the cleaning.

Troubleshooting for Error Codes (Status Display)

Error Code
Low Battery
Error code is shown when the battery runs out or MamiRobot fails in approaching to the charging station. In this
case, recharge it manually.
Trouble with Bumper or Anti-Falling Sensor
Error code is shown when the bumper is pressed or a mistaken recognition of anti-falling sensor. In this case, check
and remove the foreign substance from the bumper or sensor.
Trouble with Fan Motor
Error code is shown when the fan motor cannot run. In this case, check the status of installation of dust bin or dust
filter. If this error code is not removed, please contact Customer Care Center.
Trouble with Photosensor
Please contact Customer Care Center.
Trouble with Wheel Motor
Error code is shown when wheel motor cannot run. In this case, check and remove the foreign substance from
wheels and stators of wheel.
Wheel Sensor Warning
Error code is shown when a wheel is not touching the ground. In this case, place it down on the flat ground.
Battery Temperature Warning
Error code is shown when the battery temperature sensor detects some problem. In this case, check the status of
installing of battery.
Battery Voltage Warning
Error code is shown when the battery and main body have a bad connection. In this case, check the installation of
battery and the connection with main body.
Brush Motor Warning
Error code is shown when a foreign substance is caught in the main brush. In this case, check and remove the
foreign substance from the main brush or brush rotor.
24
ENGLISH
When power is turned on or silent mode is cancelled.
When Cleaning Time Control Button is pressed.
When battery's voltage becomes lower than 12.2 V during cleaning or Start Button is pressed
under 12.2 V.
When charging is complete.
When Damp Mop Cleaning Button is pressed.
When the wheel motor cannot run or wheels are not touching the ground .
When the battery and main body have a bad connection.
When the sensors have problem.
When a foreign substance is caught in the main brush.
When scheduled cleaning is selected.
When cleaning has been finished.
Cause and Solution