Composition And Name Of Display Panel; Operating Mamirobot - Mami Robot pporo Bedienungsanleitung

Composition and Name of Display Panel


 Status Display
 Cleaning Time Indicator
 Main Power Button

Operating MamiRobot

1. Press the Main Power Button on the main body. MamiRobot is turned on and becomes standby status.
2. In stand-by status, MamiRobot start cleaning with pressing the Main Power Button or Start/Stop Button on the remote control.
Default cleaning time is 1 hour.
3. For changing the cleaning time, press Cleaning Time Control Button on the main body or on the remote control. Each time
the Cleaning Time Control Button is pressed, working time is selected as 'Continuous' , '60 min' , '30 min' as shown in Figure.
After selecting with preferred cleaning time, start cleaning by following the step 2.
or
Default time set
4. When you press Auto-Recharge Button on main body or on the remote control, MamiRobot stops it's work and returns to the
charging station to recharge its battery.
5. When the residual battery quantity runs out, [doc] is shown in status display with beep. The machine goes for recharging
to the charging station automatically.
6. MamiRobot will be turned off automatically by pressing the Main Power Button 2 seconds.
7. When no key is pressed in 2 minutes in stand-by status, MamiRobot is automatically turned off. ( If MamiRobot is docked
with charging station, stand-by status will be held.)
8. If you will not use the machine for a long time, remove the battery from machine.
22
ENGLISH
LOW NOISE

CHARGING


 Low Noise Mode Indicator
 Scheduled Cleaning Time Indicator
 Cleaning Time Control Button
●
Continuous

CLEANING
SCHEDULE

 Charging Indicator
 Auto-Recharge Button
 Photosensor
●●
30 min



●●●
Repeat same pattern