Philips Amara View minimal contact full-face mask Gebrauchsanweisung Seite 7

Before putting on the mask:
1. Headgear - Loosen to a large setting.
2. Headgear clips - Grip and twist away from the
frame to disconnect d.
Adjusting the mask:
1. Pull the mask over your head. Hold the mask
against your face e.
2. Mask cushion - Place your nose over the
cushion nostril opening.
Push the mask cushion up .
Note: Do not place your nose in the cushion
nostril opening.
3. Headgear clips - Press into place to connect.
4. Headgear - Pull back the tabs to evenly adjust
the top and bottom straps.
Pull back the tab to adjust the crown strap.
Using the mask:
1. Connect the flexible tubing (included with your
CPAP or bi-level device) to the quick release tube.
2. Lie down. Turn the therapy device on. Breathe
normally. Keep your mouth slightly open.
3. Assume different sleeping positions. Move
around until comfortable. If there are any
excessive air leaks, make final adjustments. Some
air leaking is normal.
Comfort Tips
• The most common mistake is overtightening
the headgear. The headgear should fit loose
and comfortable. If your skin bulges around
the mask or if you see red marks on your face,
loosen the headgear.
• Adjust the crown headgear strap to lift the
straps off of your ears f .
4
5
6
5