Marcato PASTADRIVE Gebrauchs- Und Wartungsanleitung Seite 6

PRECAUTIONS AND SUGGESTIONS FOR YOUR SAFETY.
- This motor may be installed only on MARCATO pasta machines
bearing the CE safety mark.
- Always unplug the lead from the mains before starting to clean
the machine and the motor.
- Do not remove the plug from the mains with wet or even slightly
damp hands.
- Do not wash the machine, especially when it is plugged in.
- Do not allow children younger than 14 years old to use the machine.
- Do not leave the machine unsupervised, especially when it is plugged.
- Always unplug the machine from the mains before removing or applying
the motor.
- Do not use the machine near to sources of heat, (e.g. oven hob rings) or in
areas near to water (e.g. sinks)
- Use this machine only for the purposes described in this manual for no
more than 15 minutes continuosly.
- Do not insert knives or cloths in between the rollers.
- Use only the cable supplied with the machine and polarized
extension leads compatible with the current indicated on the motor plate.
HOW TO INSTALL THE "PASTADRIVE" MOTOR ON "MARCATO"
PASTA MACHINES
Even though MARCATO pasta machines with the PASTADRIVE motor may
be used without being secured, for safety reasons we recommend they are
always fixed to the table with the special clamp (Fig. 1).
When using the machine for the first time, clean it with a dry cloth to remove
any excess oil. To clean the rollers, pass a small quantity of dough through
them and then throw the dough away.
When working with the motorised machine do not wear ties, scarves, or long
chains; tie up long hair with a clip and do not let children near the machine.
Please also check that your house-hold power supply also corresponds to that
indicated on the motor plaque (Fig. 2).
To install the motor on the smooth rollers, hold it facing upwards at an angle
of 30°, bring it close to the machine and insert the pin into the roller hole
(Fig. 3).
Push the motor until it rests on the machine.
Turn the motor downwards at an angle of 30° so that it hooks onto the holes
on the side.
To detach the motor from the machine, turn the motor upwards by approx.
30° and pull it outwards (Fig. 4). Start the motor by setting the switch to
position 1 (continuous) - (Fig. 5 and 6).
6