Installation - Apex Sedens 500 Gebrauchsanleitung

Sedens500/English

3. Installation

1
4
NOTE: Unpack the box to inspect for any damage, which may have occurred during
shipping. If there are any damages, please contact your dealer immediately.
3.1 Setting Up
1. Place the seat cushion on top of the (wheel) chair. The slip-resistance mat found at the
bottom of cushion will prevent slippage.
CAUTION: The pump can only be used with the air seat cushion recommended by the
manufacturer. Do not use it for any other purpose.
2. Put the pump into the carry bag and hang the pump onto the (wheel) chair handle or frame
with the straps of the carry bag..
3. Connect air hose from the seat cushion to the pump unit.
NOTE: Check and ensure the air tubes have no kinks in them and are not tucked under the
cushion.
4. Connect the AC/DC adaptor to DC power jack of the pump unit. Plug into mains electrical
outlet..
NOTE: Use only with original manufacturer's adaptor, improper use of adaptor or charge
with adaptors other than supplied from the manufacturer will not be covered under
the warranty.
2
3
7