Troubleshooting; Technical Specifications - Saeco Cafissimo TUTTOCAFFÈ HD8602 Bedienungsanleitung

TROUBLESHOOTING

Machine actions
The machine does not turn on.
The machine needs a lot of time to warm up
or coffee temperature is too low.
The pump is noisy.
The lever cannot reach the dispensing
position.
The lever does not open completely.
The coffee is brewed too fast or the brewed
coffee is not creamy.
Coffee is not dispensed or is only dispensed
in drops.
Dispensing of the beverage is interrupted.
Coffee granules present in the coffee cup.
constantly lit.
slowly.
Please contact the Cafissimo service team for any problems not covered in the above table or if the suggested solutions do not solve the
problem. Please check for further contact information the gurantee chapter of this manual.

TECHNICAL SPECIFICATIONS

The manufacturer reserves the right to make changes to the technical specifications of the product.
Nominal voltage - Power rating - Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See plate located under the machine.
Housing material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Thermoplastic
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 x 360 x 265
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power cord length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.8 m
Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . At the top
Water tank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.7 litres - Removable
Used capsule drawer capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-7
Boiler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stainless steel
Safety devices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Thermal fuse
Job:
Objekt:
Version: --
Seite:
Causes
The machine is not connected to the mains supply. Connect the machine to the mains supply.
The machine is clogged with limescale.
Not enough water in the tank.
Water tank not inserted correctly.
Used capsule drawer full.
The capsule is not inserted correctly.
Capsule stuck.
Used capsule drawer full.
The used capsule is unsuitable for the selected
product.
Water tank not inserted correctly.
Not enough water in the tank.
The machine is full of limescale.
Not enough water in the tank.
A small amount of coffee granules always remains
in the bottom of the cup.
The machine is clogged with limescale.
Not enough water in the tank.
4219 440 12181
qInlet
q31
Solutions
Descale the machine.
Fill the water tank with fresh drinking water.
Insert the tank correctly and push it downwards.
Empty the used capsule drawer. Insert the capsule
again.
Insert the capsule again, checking that it is correctly
inserted.
moderate force to remove the capsule.
Empty the used capsule drawer.
Insert a new capsule and repeat the operation or check
the colour of the capsule.
Insert the tank correctly and push it downwards.
Fill the water tank with fresh drinking water.
Descale the machine.
Fill the water tank with fresh drinking water. Press
the corresponding button of the interrupted beverage
without inserting a new capsule. Stop dispensing upon
reaching the desired quantity by pressing the beverage
button again.
This is normal and not a defect.
Descale the machine.
Fill the water tank with fresh drinking water.
Datum: 14-06-24
Uhrzeit: 09:13:17
von: timea.trojko