Pfaff Silverline Betriebsanleitung Seite 9

Ratchet lever hoist SILVERLINE
English
Notes on using the ratchet lever hoist
N.B.:
Before use, make sure that the intended suspension points can safely cope with the loads.
The user must make sure that the suspension points are big enough.
Operating instructions
Safety information
Ratchet lever hoists are suitable for manual operation only.
The load may only be suspended from the load hook.
Hang the load from the hook in central position only.
Lifting:
Set the selector switch to the position"UP".
Turn the lever (ratchet) clockwise to lift the load.
Lowering:
Set the selector switch to the position"DN".
Turn the lever (ratchet) anti-clockwise to lower
the load.
Chain release:
Activate only in the unloaded state.
Set the selector switch to"FREE".
Turn the handwheel anti-clockwise to release the
unloaded chain.
Never use the release function under load.
You can now pull the chain through by hand.
For freespooling of the medium it may be
possible to open the brake system only under
the condition of low lowding.
The brake system shall automatically apply when
the load on the lifting medium is grater than 30
kg for capacities up to 1000 kg, and greater than
3% of the rated load above 1000 kg.
In this respect, the load shall not be allowed to
descent more than 300 mm, before the brake
acts to stop the load falling.
subject to change
F03.01.051/002
page 9
Senken
lowering
baisser
Heben
lifting
lever