Intended Use; Safety Instructions - Pfaff Silverline Betriebsanleitung

Ratchet lever hoist SILVERLINE
English
Read the operating instructions carefully before using the hoist for the first time
Follow the safety instructions
Keep this documentation in a safe place

Intended use

The ratchet lever hoist is designed for the lifting, lowering, pulling and lashing of loads.
The use of mechanical drives with this ratchet lever hoist is prohibited.
This ratchet lever hoist is not suitable for use in locations subject to explosion hazards.
This ratchet lever hoist is not suitable for use in aggressive environments.
Our express written permission must be obtained in advance before making any modifications to this
ratchet lever hoist and before fitting any attachments to it.
Be sure to read the "Technical data" and the "Description of functions"!
Accident prevention regulations
The regulations in force in the country of use must be observed.
The regulations currently in force in Germany are:
BGV D 8 Winching and pulling devices
BGR 500 chapt. 2.8 Load suspension devices for hoisting operations
DIN 685 Part 5
DIN 5684 Part 3
EN 818-7
EC Directive 98/37/EC
1) in the currently valid version

Safety instructions

Operation and maintenance are to be performed only by:
Authorized, qualified personnel
(Definition of skilled workers according to IEC 364)
Qualified personnel are persons who, by virtue of their training, experience, instruction and knowledge of pertinent
standards and provisions, accident prevention regulations and operating conditions, are authorized by those
responsible for the system's safety to perform an essential activity and who are able to recognize and avoid the
hazards which may arise in connection with the activity in question.
The ratchet lever hoist must not be used to convey persons. No persons are allowed to remain within the
hoist's danger zone.
It is prohibited to stand underneath a suspended load.
Never reach into moving parts.
Defects must be rectified immediately by expert personnel.
Never leave a suspended load unsupervised.
High-strength parts such as chains, hooks and transmission components should be kept clear of free
hydrogen, acids, alkalis, vapors and very aggressive cleaning agents. Risk of brittle failure.
The chain
is designed only for the lifting, lowering or pulling of diverse loads. It should not be used for any other
purpose.
should not be used as slinging tackle.
should not be pulled over sharp edges.
should not be twisted.
should not be extended.
should be regularly tested and serviced in accordance with DIN 685 Part 5.
subject to change
F03.01.051/002
1)
page 7
!