ASROCK P45XE-WiFiN Installationsanleitung Seite 25

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 25 or p.3 No. 24)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2/3 No. 9)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (Port 0):
see p.2, No. 17 or p.3, No. 16)
(SATAII_2 (Port 1):
see p.2, No. 15 or p.3, No. 14)
(SATAII_3 (Port 2):
see p.2, No. 18 or p.3, No. 17)
(SATAII_4 (Port 3):
see p.2, No. 13 or p.3, No. 12)
(SATAII_5 (Port 4):
see p.2, No. 21 or p.3, No. 20)
(SATAII_6 (Port 5):
see p.2, No. 19 or p.3, No. 18)
SATAII_5 (Port 4) and SATAII_6 (Port 5) connectors can be used for
internal storage device or be connected to eSATAII connectors to
support eSATAII device. Please read "eSATAII Interface Introduction"
on page 30 for details about eSATAII and eSATAII installation
procedures.
ASRock P45XE-WiFiN / P45XE-R / P45XE Motherboard
These six Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
SATAII_6 SATAII_4 SATAII_2
(Port 5) (Port 3) (Port 1)
SATAII_5 SATAII_3 SATAII_1
(Port 4) (Port 2) (Port 0)
the red-striped side to
Pin1
connect the black end
to the IDE devices
2 5 2 5 2 5
2 5 2 5