Declaration Of Conformity; Technical Data; Maintenance And Care - Conrad GT750 Bedienungsanleitung

• Start your GPS routing software with the relevant route data of the route that you visit. Make
sure that your software is set to COM port (this is usually already set by default). You can now
use your GPS software in accordance with its operating instructions; other settings might be
required. Observe, however, the operating instructions on the software.
• At initial start-up, or if you have transported the turned off Bluetooth GPS Logger more than
500 km, we recommend that you position the Bluetooth GPS Logger outdoors (direct line of
sight) to ensure a perfect reception and correct positioning.
• To turn the Bluetooth GPS Logger off, press and hold the „ON/OFF" button (4) for about 2 sec-
onds.
Reception
Reception problems may arise in the following situations:
IGPS signals are blocked in tunnels.
Covering the device will lead to the suppression of the GPSsignal
reception.
The GPS signal is blocked inside buildings.
In lateral buildings (especially in high buildings, such as sky-
scrapers), the GPS signal is low and reception problems may
arise.
In forests, or when crossing densely vegetated areas, the GPS
signal is low and disturbances may arise.
Other reasons for a reduced reception quality and/or disturbances of the receivedsignal:
• In vehicles, sun visors can reduce or completely block the signal reception.
• walls, reinforced concrete ceilings
• coated/metallised insulated glass
• Proximity to metallic and conductive objects
• Broadband interferences, e.g. in residential areas (DECT telephones, mobile phones, radio-
controlled headphones, radio-controlled speakers, radio-controlled weather stations, baby
phones etc.)
• Proximity to electric motors, transformers, power-supply units, computers
• Proximity to improperly shielded or uncovered operating computers or other electric appli-
ances

Maintenance and Care

The product does not require any maintenance and should never be opened or disassembled
for any reason.
Clean the product with a soft, clean and dry cloth. Never use aggressive cleansing agents or
chemical solutions, since they might damage the surface of the housing.
Disposal
a) In general
Please dispose of the device when it is no longer of use, according to the current statutory
requirements.
b) Batteries and rechargeable batteries
As the end user, you are required by law (Battery Ordinance) to return all used
batteries/rechargeable batteries; disposal of them in the household waste is prohibited!
Contaminated batteries/rechargeable batteries are labelled with these symbols to
indicate that disposal in the domestic waste is forbidden. The designations for the
heavy metals involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead.
Used batteries, rechargeable batteries as well as coin cells can be returned to col-
lection points in your municipality, our stores or wherever batteries/rechargeable
batteries/coin cells are sold!
You thus fulfil the legal requirements and make your contribution to protecting the environment!

Declaration of Conformity

We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau (Germany), hereby declare
that the product conforms to the fundamental requirements and the other relevant regulations of
Directive 1999/5/EC.
You can find the declaration of conformity at www.conrad.com.

Technical Data

Power supply: via supplied battery 3.7V/DC (1000 mAh,
LI-ION) or via 12-24V/DC car charger
Operating temperature: -20°C to +60°C
Dimensions: approx. 74 x 44 x 22 mm
Weight: approx. 60 grams
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2009 by Conrad Electronic SE.