Default Settings; Software-Update; Alarm Clock; Backlight - Block CR-10ToGo! Bedienungsanleitung

Default settings

Selecting and confirming this item resets all settings to the factory settings.
Please use this function if you have problems receiving data from the Internet or the general operating
software of the device. You should also perform this function if you want to resell the device. A restart after
executing the factory settings restarts the setup wizard.
Software update
The CR-10ToGo! regularly checks and informs you whether an update is available on the Internet. You can set
this function for manual update (not recommended), or to update the operating software.
Setup Wizard:
Selecting and confirming this item starts the setup wizard. All settings that you then make overwrite the old settings.
Info
Selecting and confirming this item will show you technical information about the installed software version,
the manufacturer ID of the device, and the name under which your device will be displayed on the network.

Backlight

Here you can separately adjust the brightness of the display during operation and in network standby mode.
1. Time until dimming: this value indicates the time after which the backlight of the display darkens after swit-
ching to network standby.
2. Display brightness: this item controls the brightness of the display during operation.
3. Dim brightness: if you have entered a time value under point 1, this point determines the brightness to
which the display will be displayed after the selected time Network standby.
Multi-room
In this menu you can group the CR-10ToGo! with multiple speakers in different rooms. We recommend using
the free app „UNDOK ™" for the configuration. Please also read the enclosed instructions for the app „UNDOK
™".
56
Additional comfort features
Press the „Menu / Info" button on your remote control or on the device and select the item Main menu. In the
following menu you can also select Snooze and Alarm in addition to the already known signal sources:
Snooze
Select Snooze on your remote control with the arrow keys and confirm with the „Enter" key. The message
„Sleeping Off" appears. With the „Up arrow" and „Down arrow" buttons, you can now set the desired period of
time after which the device will automatically switch to standby mode. Your setting will be taken over automa-
tically after a short time. Exit this menu by pressing the „Menu / Info" button again. At the bottom of the display
an icon will indicate the selected time until switching to the network standby.

Alarm clock

Select Alarm Clock on your remote control with the arrow keys and confirm with the key
„Enter." The „Alarm clock" menu appears. Now you have the option to set two different alarm clocks. For
example, select the first alarm clock. In the following menu, you can switch this alarm on and off, set the time,
choose between daily, single days, weekends etc., set the signal source with which you are awakened and
adjust the volume. Please do not forget to save this alarm by using the last item in the menu!
Exit this menu by pressing the „Menu / Info" button again. The display will show at the bottom an icon for each
programmed alarm clock and the alarm function is active.
If the alarm clock becomes active at the selected time, you have two options:
1. Snooze: press any button on the remote control or on the device except the „Standby" button. The unit will
now display the time until the alarm is reactivated, with the „Up / down arrow" or „Vol +/-" buttons you can
change this period.
2. Turn off the alarm clock: press the „Standby" button on the device or on the remote control to switch off the
alarm clock. The alarm will become active again as soon as possible depending on the programming.
To turn off the alarm completely, follow the instructions above and set the alarm to Off..
57