Showing The Map Display (Map); Manually Switching Monitors On/Off; (Mon); Selecting The Video Source For The Driver (Cam) - Bosch CCA 47 Bedienungs- Und Einbauanleitung

Source selection
button 9 to switch the
Ñ
Press the or
second video source on or off.
To exit the menu,
Ñ press the MENU button :.
Controlling video playback
To start the video playback,
button 9.
Ñ
press the
To stop the video playback,
button 9.
Ñ
press the
For fast searching forward or reverse (or
chapter skipping forward/reverse for DVD
playback)
button 9.
Ñ
press the or
To return to the normal playback speed,
Ñ button 9.
press the

Showing the map display (MAP)

If a navigation system and an RGB/FBAS
converter or a CLX monitor are connected to
the device, you can show the map display of
the navigation system on the monitors in the
cabin area.
To show or hide the map display,
press the MAP button 8.
Ñ
If the map display is shown, the display shows
the MAP symbol.
Robert Bosch Car Multimedia GmbH

Manually switching monitors on/off

(MON)

The monitors in the cabin area can be switched
on and off manually.
Press the MON button <.
Ñ
The display shows "MON ON" or "MON OFF".
If the monitors are switched on, the MON
symbol is shown on the display. When you
switch off the monitors, the corresponding
relay switches off with a delay of approx. 4
seconds.
Selecting the video source for the
driver (CAM)
Connected cameras can be shown as video
source on a monitor in the cockpit (e.g. CLX).
These cameras can be used, for example, for
the rear view from the bus or for monitoring the
cabin area. In addition, a second video source
can be connected here, e.g. the map display of
a navigation system.
To display the camera and video images on the
cockpit monitor,
press the CAM button 7.
Ñ
To switch between different cameras and video
during the playback,
press the CAM button 7 once or several
Ñ
times.
While the playback is active, the display shows
the CAM symbol.
7 620 210 013 | 10.2009
en | 19