Hama RC 130 Bedienungsanleitung Seite 4

5.4. Alarm settings and display
• Press the mode button (4) repeatedly until AL1 is displayed.
• Hold the mode button (4) for approx. 3 seconds. The hours display begins to flash.
• Press the p button (2) or the q button (3) to select the hour for the alarm time and confirm your selection
by pressing the mode button (4). The minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time. Once you have confirmed your minutes selection
with the mode button (4), alarm 1 is activated and
• You can also set a second alarm time.
• Press the mode button (4) repeatedly until AL2 is displayed and repeat the settings for AL1.
• Press the button (6) to activate/deactivate alarm time 1, alarm time 2 or both at once. The alarm
symbols and/or will appear/not appear.
2
1
• If the alarm is triggered, the corresponding alarm symbol will begin to flash and an alarm will sound.
• Press the button (6) to stop the alarm. Otherwise, it will stop automatically after 4 minutes.
• If you press the SnOOZE / LIGHt button (1) during the alarm, the alarm is interrupted for 4 minutes and
then goes off again. The corresponding alarm symbol and the snooze symbol
5.5. Settings and display for a second time zone
• Press and hold the p button (2) for approx. 3 seconds to display the second time zone as the main time.
The symbol appears next to the time.
F
• Press the mode button (4) repeatedly until the temperature is displayed.
• Press and hold the mode button (4) for approx. 3 seconds to set a second time in another time zone. The
hours display begins to flash.
• Press the p button (2) or the q button (3) to make the setting and confirm your selection by pressing the
mode button (4).
• To switch to the current local time, press and hold the p button (2) again for approx. 3 seconds.
The symbol is no longer displayed.
F
6
appears.
1
Z Z will flash.
5.6. Dual time settings and display
• Press the mode button (4) repeatedly until DUAL tIME is displayed.
• Press and hold the mode button (4) for approximately 3 seconds. The hours display begins to flash.
• Press the p button (2) or the q button (3) to make the setting and confirm your selection by pressing the
mode button (4). The minutes display begins to flash.
• Repeat the process to set the minutes.
5.7. temperature display
• Press the mode button (4) until the temperature is displayed.
• Press the °C/°F button (5) to choose between °C and °F for the temperature display.
5.8. Backlight
If you press the SnOOZE / LIGHt button (1), the display will light up for approx. 5 seconds.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
7