Connecting The Wireless Lan Router; Configuring The Operating System And Computer - Hama 00062735 Bedienungsanleitung

Note! The "Connect as required" setting is recommended for volume or timed rates, so that the
internet connection is disconnected automatically after the period set in the „Idle time"
option. Connection costs may be high if permanently connected. Please also note that
closing the browser does not automatically disconnect from the internet. Many programs
send queries to the internet or receive data from it without this being clearly visible. For the
router, these queries are just as valid as opening a browser, for example. If you want to
ensure that there is no active connection to the internet, you should switch off the device or
disconnect it from the modem.

1. Connecting the Wireless LAN Router

1. Connect the computers and other network devices such as hubs/switches to sockets 1-4.
Use a crossover or CAT5 patch cable (max. 100m). The integrated switch automatically
identifies the connection speed of 10 or 100Mbps, half/full duplex transfer mode and the type of
cable used.
2. Connect the Ethernet port of your modem to the WAN connection on the router. A 1:1 or crossover
cable is required depending on the modem. In most cases, the existing connection cable can be
used.
3. Plug the power unit supplied into an empty socket and connect it to the router. Caution:
Unsuitable power supply units can cause damage!
Checking Installation
There are various status indicating LEDs on the top of the device:
LED Condition
Power Illuminated
Off
WLAN Flashing
Off
WAN Illuminated
Flashing
Off
LAN1-4 Illuminated
Flashing
Off
2. Configuring the operating system and computer
The TCP/IP protocol must be installed on all PCs that will be using the Internet. By default, the
IP address 192.168.2.1 and an activated DHCP server are configured for the router. This means that the
connected PCs are automatically given appropriate addresses and other settings. We recommend using
these settings.
Proceed as follows to check the settings on your PC:
Start -> Settings -> Control panel -> Network connections
Status
Power unit is connected and supplying electricity
No power unit connected, device not being supplied with electricity
Wireless LAN is activated / data is being sent
Wireless LAN is deactivated
The WAN port has generated a correct network connection
Data transfer via WAN port
No connection
The corresponding LAN port has generated a correct network connection
Data transfer via respective LAN port
No connection
3