Anschlussbeispiele; Starting Up The Product - flamco WMS 2-1 Montage- Und Betriebsanleitung, Originalbetriebsanleitung

Anschluss-Beispiele
Fig. 5: Wiring example WMS 2-1
CAUTION FUNCTIONAL IMPAIRMENT OF ELECTRICAL EQUIPMENT DUE TO
VOLTAGE SPIKES WHEN SWITCHING OFF INDUCTIVE LOADS.
Wire inductive loads with commercially available standard RC combinations, e.g.,
f
0.1 µF/100 ohms.
6.4

Starting up the product

Check that the signaling unit and sensor are installed as per Chapter 6, Page 11.
R
Check that the sensor is leak tight.
R
Check that heating water has been topped up.
R
Check the electrical connection was implemented as per Chapter 6.3, Page 15.
R
Check that the sensor is connected to the signaling unit.
R
Check that the output relay is connected (if appropriate).
R
Check that the external power failure interlock has been implemented.
R
Check that the mains connection is in place.
R
Check that the ribbon cable is connected to the circuit board.
R
Check that the signaling unit is closed and fastened.
R
1
Mains fuse F1
2 Sensor
3
Boiler
4 External release
(optional)
5 External alarm
(optional)
6 Release contactor
7
Supply voltage
15