Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
N.B. This equipment must be installed by a competent person and a risk assessment
undertaken as to the suitability of the chair for the particular user.
127kg (20 st) weight limit
Do not exceed the weight limit stated as doing so could put the user at risk
ASSEMBLY
The chair is provided to you packed in cube form. Please examine all components for any visible damage
before use. If you see any damage or suspect a fault, please contact your supplier immediately.
In this case, please do not use your product as it may compromise the safety of the user.
NB. When transferring sideways from the chair, a risk assessment may be needed as to the
suitability of the chair for the particular user.
NB. Arm rests are for comfort only.
NB. Indoor use only.
NB. When pushing the chair, attendants must not 'ride' (i.e. put all their weight) on the pram
handle.
The package contains the following components:
The main frame with four braked castors attached
•
Detachable grey horseshoe aperture seat (attached to the main frame)
•
Grey horseshoe seat infill
•
Detachable back
•
Detachable footrests
•
PLEASE READ THESE FOLLOWING INSTALLATION INSTRUCTIONS CAREFULLY.
1.
Remove all contents from the box
2.
Remove the white cardboard packing tubes taped around the frame (this is to prevent
damage during transit and not part of the chair)
3.
Place the assembled base on a level floor
4.
At the rear of the chair (or removable back) you will see two black threaded wheel nuts; undo
the wheel nuts and remove from the frame
5.
Place the two legs of the back into the locating holes at the rear of the chair frame
6.
Re-insert the black nuts through the frame and back and secure by turning the black lock nuts
until you feel the nut biting against the leg of the back
7.
Do not over tighten
8.
Do not use tools as it is only necessary to have the back secured finger tight
FOOTRESTS
Your footrests may be packed separately to the main chair. Please examine your footrests for any visible
damage before use. If you see any damage or suspect a fault, please contact your supplier immediately.
In this case, please do not use your product as it may compromise your safety.
1.
Remove the footrests from their packaging.
2.
You will see on each of the front legs of the main frame about 150 mm high from the castor 2
retaining lugs either side.
3.
Take the footrests and align the holes in the inverted 'U' section with the lugs and lower down
into place.
4.
Rotate the footrests towards the commode so that they clip into place.
Assembly and Operating Instructions
2
Ver. 6 05/2014 (1261)
Werbung
Inhaltsverzeichnis
