Belkin F1DD102Lea Schnellinstallationsanleitung Seite 2

Single-Switch Installation
This section provides complete instructions for the hardware setup of a single KVM Switch.
(F1DD102Lea or F1DD104Lea)
Installing the KVM Switch
The KVM Switch is a plug-and-play device for installation. For a quick start on installation
and operation, please follow the instructions below for the setup sequence:
Step 1.
Connect the shared keyboard, monitor,
and mouse (also speaker set and
microphone) to the console port of the
KVM Switch.
Step 2.
Connect each of your computers to the
KVM Switch, using the DVI/USB KVM
cable, and audio and mic cables.
Step 3.
Connect your KVM Switch by
connecting the external power
adapter to it.
Step 4.
Power up the connected computers one by one. After your computers are powered up,
the keyboard and mouse will be recognized and you can begin using the KVM Switch.
NOTE: Since the USB interface is hot-pluggable, you don't have to turn off the computer before
making connections to the KVM Switch.
4 3 2 1