Cardo scala rider G4 PowerSet Gebrauchsanleitung Seite 5

the left ear [A] and the long speaker cord [B] for the
right ear). You may want to use the supplied Velcro
pads.
Using two speakers inside the helmet may be pro-
hibited in certain jurisdictions. If this is the case, you
should tuck away the long corded speaker
underneath the helmet padding as follows:
Lead the speaker cord [B] alongside the rim of the
padding to the right side and then back to the left
side, near speaker [A]. Then place the speaker [B]
underneath the padding.
Cable
USING THE MP3 PLAYER WITH YOUR HEADSET
Speaker B
Your scala rider headset can be connected to an MP3 player device by
simply plugging it to the Clamp's jack with the MP3 cable as follows:
1. Power on the headset to have it on Standby mode, flashing slowly in
Blue.
Speaker B
2. Connect one side of the MP3 cable to your
MP3 player device's jack and the other side
to the Helmet Clamp's jack as shown in the
photo.
Speaker A
NOTE: Operate the MP3 Player device by using its buttons (FF/REW/PLAY/
PAUSE). Volume can only be adjusted through the MP3 Player.
Any other audio connection will automatically mute the MP3 Player. The
audio signal will return only when headset is once again in Standby mode.
MP3 /
Aux
jack
Audio & Microphone Kit 5