Werbung
Verfügbare Sprachen
Verfügbare Sprachen
be guaranteed and no liability is assumed by the manufacturer.
Should changes be made to the laser, installation accessories,
connection and fastening elements or lifting equipment and
slings, the load carrying viability of the system can not be gua-
ranteed and no liability is assumed by the manufacturer. Repairs
made to safety relevant components may only be undertaken
by the manufacturer or authorized personnel; otherwise the
operating authorization is void.
Installation must be carried out exclusively by qua-
lified personnel and exclusively at assembly points
with sufficient load-bearing capacity, while also
conforming to local building regulations. The mounting materi-
als (screws, dowels etc.) prescribed by the manufacturer in the
installation instruction must be used. Bolted connections must
be secured against loosening through appropriate measures.
Fixed or mobile installations must be secured with
two independently acting safety mechanism against
falling. Loose fittings or components and parts that
become detached must be able to be collected by appropriate
equipment. National Regulations must be observed with the
use of connection and installation elements as well as lifting
equipment and slings. With regard to the assessment of safety
precautions, the results of dynamic loads (jerk forces) are to be
taken into account.
The maximum load capacity is to be observed with
stands. Additionally, please note that stands are
constructed and approved to carry the load in the
structural centre. Stands must be placed upright on solid and
stable foundations. Stands must be secured additionally by
suitable measures, if for example:
> the foundation surface does not allow for a stable stand.
> the height restricts the stability.
> exposure to strong winds is expected
> the possibility exists for the stands to
be knocked over by people.
Special measures may also be required as a precaution against
endangering spectators. Stands must not be placed in escape
routes. In the case of stands being placed in roads, regulations
concerning the width of the road as well as the appropriate
closing off of the road with the correct signage thereof must be
followed. Lifting, moving and placing back down exposes one
to risk. To this end, appropriate tools should be used. In this
case, national regulations must be followed.
During installation, protective clothing should be
worn and equipment used at all times (especially
head protection, gloves and safety shoes) and only
suitable lifting equipment (ladders, scaffolding) should be used.
The responsibility for this lies solely with the installer.
ATTENTION!
After installation the mounting system and the laser
must be checked for a secure hold. The operator
of the laser system (fixed or mobile) is obligated to check or to
have checked all system components on a regular basis, taking
into account the respective national regulations and to imme-
diately eliminate potential damage. Furthermore, we strongly
recommend detailed documentation of all control measures.
Wind loads, snow and ice loads as well as thermal effects are
to be taken into account for the stability and viability of the
laser system which are permanently, or for long periods of
time, located outdoors as well as the structures and surfaces. In
particular, the load bearing points of flown systems should be
dimensioned as too allow for sufficient safety reserves. In this
case, national regulations are always to be followed.
• Please consult the manufacturer to see if your
speakers are suitable for outdoor use.
Important Safety Instructions!
Caution:
Avoid direct eye contact with the laser beam. Never expose the
eyes directly to the laser.
Caution:
This laser product can potentially cause immediate eye injury or
blindness when the laser beam falls directly on the eyes.
Caution:
It is illegal and dangerous to place this laser in public areas in
which the audience's or other staff member's eyes could be
directly exposed to the laser beams or bright reflections.
Caution:
There are no user serviceable parts inside. Do not open the case
or attempt to repair it yourself. In the unlikely event that your
device requires a service, please contact your nearest dealer.
Warning:
This unit contains high-power laser diodes. Never open the
housing. The laser beam may cause immediate blindness, skin
burns and fires when the device is opened.
Always operate the product in accordance with the
official standards and regulations for the use of laser
beam devices!
Manufacturer: MUSIC STORE professional GmbH,
Istanbulstraße 22-26, 51103 Cologne, Germany
7
Werbung
