Worx Landroid Installationsanleitung Seite 14

Open the keypad window
by pressing the large red
button on the top of your
Press and hold down the
Power ON/OFF
until the Landroid
Press the key and close
the keypad window: your
Landroid will now find its way
®
2 3
to the charging base.
1 2 3
Watch the Landroid
5 6
4 5 6
returns to the charging base
8 9 0
7 8 9 and modify the positioning 0
of the boundary wire if
necessary. When the
Landroid successfully returns
®
to the charging base, this
means the installation has
been successfully completed!
Now your Landroid
to fully charge.
NOTE: If your Landroid
14
button and close keypad window to send it back to mowing.
EN
Warning
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
2
Landroid .
®
key
® turns on.
1 2
as it
®
4 5
7 8
will start
®
is in the charging base during a time you have programmed it to mow, then simply press the ACCESS
®
• If your Landroid is • If your Landroid
®
outside its territory, it inside its territory but
will not move and the the display says "out
display will indicate of cutting area" , and the
"out of cutting area" LED is on, it means you
error. Just move it inside clamped the boundary
its territory and repeat wire ends incorrectly.
step 2. Just reverse them.
3
1 2 3
6
4 5 6
9 0
7 8 9 0
is • Your Landroid
®
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
1 2 3
1 2 3
4 5 6
4 5 6
7 8 9
7 8 9 0
should • Should your Landroid
®
stop operating
unexpectedly, just press
the ACCESS button, open
its keypad window, press
its ON/OFF key to ON,
correct the problems,
0 button, close its keypad
window.
0
®
press