Brief Description / Scope Of Application; Installation; Mounting - Ceag IP65 Montageanleitung Und Bedienungsanleitung

5.1 Brief description / Scope of application

As a self contained luminaire the 6811 LED CGLine emergency luminaire is suitable for installations
acc. to EN 50 172, DIN VDE 0100-718 und E DIN VDE 0108-100. With the CEAG CG-Controller CG-
Line 400 or the CGLine PC-Interface the self-contained luminaires can be monitored centrally via a
bus cable.
6. Installation / Operation
For the mounting and operation of electrical apparatus, the respective national safety
regulations as well as the general rules of engineering will have to be observed!

6.1 Mounting

Open the luminaire by loosing the screws sideways of the bottom part of luminaire (7). Remove the
pictogram cover (1). Loose the module carrier (2) by the screws (3) to get to the electrical fitting (5).
Introduce mains cable through the cable entry of the bottom part of luminaire (7). By means of the
two bore holes (8) in the back side of the luminaire the luminaire can be fixed. For IP-protection use
the enclosed sealing discs!! Connect the battery wire (red) to + (plus) and blue to - (minus) on the
printed circuit board. Connect the bus cables to the CGLine bus-terminals.
Mains cable should be connected to the terminals N, L, L' and PE on the printed circuit board,
where L is an unswitched permanent connection for the electronics and L' is used for switching the
lamp on and off with a light switch as and when required.
Optionally, every luminaire can be operated with light switching (switched maintained light), in non
maintained mode or in maintained mode.
L
L
L'
N
PE
Operating Instructions
Self contained LED luminaire IP65
6811 1-3/D LED CGLine
non maintained
switched
light without and
maintained light
maintained light
with jumper L+L'
Operation mode switch S1
OFF ON (1h/3h)
Connection
LED Module
Button/
LED-
ON connection
3h 1h
CGLine-Bus
connection
black
wire
connector
CEAG Notlichtsysteme GmbH
11