Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DC 16+17
Please read the entire manual carefully before using the quick release!
Technical Specifications
Material
Front axle
Rear axle
Lever
excenter/ end-nut
The axles are thinner in the middle, letting the lines of force pass below the thread. This lessens the
notch effect and takes stress off the thread.
Mechanism
Thread
Weight
Instructions
The Tune DC 14 quick release skewers can be used with suspensions forks!
If the axle is too long it can be shortened, but this voids the warranty on both the thread of the axle and
the nut. The warranty on the stability of the axle remains intact. If the axle is shortened, the ends have
to be deburred, so that the nut can be screwed on easily.
Please make sure that the wheel is properly positioned in the drop-outs before closing the skewers.
The threadless part of the axle must not protrude from the drop-out! Clamping would be impossible.
This quick release is without any spring as the clamping force could be effected negatively thereby.
MTB - quick releases
Manual
Titanium TiAL6V4
Titanium TiAL6V4
Carbon/Aluminium 7075
Aluminium 7075
excentric ball
Fine thread M5x0,5
36g (pair)
Installation
Close the quick release skewers by first screwing on the end nut until it touches the drop-out. Then
close the quick release lever, open it again and tighten the end nut once more if necessary. After this,
you can close the quick release lever so far that it is located behind or before the frame i.e. fork.
Please, if necessary do not be afraid of damaging the skewers by high tension. They are designed to
withstand any clamping force. The concave "pan" on which the excenter runs is covered by a dry
lubricant. Do not oil or grease them!
Do obtain maximum life of this bonded coating keep the surfaces clean. It is possible to change the
position of the lever even in the close-position by turning a few degrees left or right.
After having closed the lever, the axle should protrude by at least one whole turn of thread. Make sure
the lever does not reach out of the frame to prevent involuntary changes of position.
Warranty
We grant a two year warranty from the date of purchase on TUNE products. Warranty claims can only
be made if a copy of an original dealer invoice is presented. The warranty includes material defects
and production errors, but not damages caused by
- normal wear
- improper use
- disregarding the service instructions/ manual
- unprofessional repair and maintenance work
Warranty claims have to be sent in to the local Tune distributor and are subject to the assessment of
TUNE U. Fahl. Based on this warranty sheet, the company TUNE U. Fahl is not liable for
compensation, especially not for indirect damage caused by accidents, collateral damage and
consequential damage. We cannot guarantee a consistency of colours because colours will be
bleached by sunlight.
The satisfaction of our customers is very important to us! Therefore, we usually handle problems with
our products with goodwill, even if the case is not covered by our warranty. We are known for our quick
handling of reclamation issues. Please send us only clean parts and include a letter with a description
of the problem or defect, your contact information and a copy of the invoice.
Tune U. Fahl, Im Mittelfeld 18, 79426 Buggingen. GERMANY
phone. +49 - (0)7631 - 74 807 - 40
Fax. +49 - (0)7631 - 74 807 - 58
service@tune.de
Outside Germany, please contact your country´s Distributor first!
www.tune.de
Werbung
