Manual Scanning; Auto Scanning; Reset To Factory Defaults - Samsung DTB-9401F Gebrauchsanweisung

OPERATING THE RECEIVER

1.1 Manual Scanning

To tune-in new channels and weak signals, the DTB-9401F has been provided with the
option "Manual Scanning" where the channel data can be entered by the user.
After selecting the "Manual Scanning" from the Installation Menu, the following screen
will be displayed:
● Select the channel which you want to find.
●
Input the frequency of the channel you want to find.
●
Select the bandwidth.
You can select the value of 6, 7 or 8 MHz.
● Select the FFT (Fast Fourier Transform) Mode.
You can select the value of 2K or 8K.
●
After select option, press the OK key to start the
scanning process.
GB-18
D I G I T A L T E R R E S T
OPERATING THE RECEIVER

1.2 Auto Scanning

The sub menu "Auto Scanning" will enable download of the channels automatically
from the preprogrammed load.
To download channels automatically:
● You can select All or Only Free option mode.
All : Scanning all the channels
Only Free : Scanning free channels
● Select the FFT (Fast Fourier Transform) Mode.
You can select the value of 2K or 8K.
●
Setting the maximum or minimum frequency.
●
Press the OK key.
Auto Scanning menu will be displayed.
All the channels in the list will be automatically downloaded.

1.3 Reset to Factory Defaults

This to restore the factory set values in case the user
has encountered some problems after changing any values of
channel data and others which may be in error.
At the request window,
if you press the OK key, the receiver will be reset to factory
default settings automatically.
N N o o t t e e : This cause your previous settings to be deleted!
R I A L R E C E I V E R
GB-19