Programmable Auxiliary Functions - Kenwood TK-x302 series Bedienungsanleitung

PROGRAMMABLE AUXILIARY FUNCTIONS

Your dealer can program the Side 1 and Side 2 keys each with
one of the following functions.
■ None
No function has been programmed.
■ Call 1
Sends the 5-tone Encode code assigned to the Call 1 key.
■ Key Lock
Press and hold this key for 1 second to lock/ unlock the
transceiver keys.
■ Key Lock with Status Memory
This operates the same as Key Lock except that when the
transceiver power is turned OFF and then ON again, the
keys remain locked. Without Status Memory, when the
transceiver power is turned OFF and then ON again, the
Key Lock function will be cancelled.
■ Monitor
Momentarily press this key to deactivate QT or DQT
signaling. Press the key again to return to normal operation.
■ Monitor Momentary
Press and hold this key to deactivate QT or DQT signaling.
Release the key to return to normal operation.
■ Scan
Press this key to start scanning the transceiver channels.
■ Scan + Temporary Delete
Press this key to start scanning the transceiver channels.
When Scan pauses at an undesired channel, you can
remove that channel from the scanning sequence by
pressing and holding this key for 3 seconds.
7