HomeMatic HM-PB-2-WM55 Montage- Und Bedienungsanleitung Seite 37

• Now, the actuator has to be put into teach mode.
• If teaching of rocker buttons is successful, it is
indicated with an illuminated green LED.
• The lower rocker button is defined for the
instructions OFF, DOWN or DARKER and the
upper rocker button for the instructions ON, UP or
BRIGHTER. Dimming occurs by holding the button
pressed.
• If you want to exit configuration mode, press the
teach button again.
Note: If no teaching occurs, teach mode
is automatically ended after 20 seconds. If
another device is in teach mode, this is taught.
If the push button is already taught for a center and
therefore is blocked for direct training, it can still be put
in configuration mode as described above, the device
LED is illuminated in red for 2 seconds after pressing
an operating button however. Direct teaching is not
possible!
After teaching, in the operation mode simple ope-
rating functions are available. The 2 buttons (on a
common rocker) can be controlled by pressing
( ) up or down ( ) shortly. Pressing up ( ) triggers
the functions ON, UP or BRIGHTER, pressing down
37