Maintenance work
Replacing the waste bag
Clean the cleaner thoroughly before replacing the
waste bag – see section "Cleaning the filter element".
During the following work, ensure that dust is
not unnecessarily spread around. Wear a P2
breathing mask.
IMPORTANT: Press the filter bag connection firmly
on to the inlet fitting.
Replacing the filter bag
During the following work, ensure that dust is
not unnecessarily spread around. Wear a P2
breathing mask.
4. Dispose of the filter bag in accordance with legal
regulations.
5. Place a new filter bag into the cleaned tank as de-
scribed in the instructions (printed on the filter bag).
IMPORTANT: Press the filter bag connection on the
inlet fitting as far as possible.
Replacing filter element
1. Open the
retaining clamps
and remove the
upper section of
the cleaner from
the dirt tank.
2. Carefully remove
the waste bag
connection from
the inlet fitting.
3. Close the waste
bag connection
with the slide.
4. Close the waste
bag using the
cable binder.
5. Dispose of the
dirt in accor-
dance with legal
regulations.
6. Insert a new filter
bag into the
cleaned tank as
described in the
instructions
enclosed.
7. Check the antistatic clamp (5) for damage and
1. Open the
have it replaced by PROTOOL Service if
retaining clamps
necessary.
and remove the
upper section of
VCP 450 E-H AC
the cleaner from
the dirt tank.
2. Carefully remove
the filter bag
connection from
the inlet fitting.
3. Close the filter
bag connection
with the slide.
10. Fit a new filter element.
11. Fit the filter holder. Ensure that it is in the
During the following work, ensure that dust is
not unnecessarily spread around. Wear a P2
breathing mask.
1. Open the
2. Open the bar
3. Remove the filter
4. Place the pro-
5. Carefully remove
6. Clean the filter
VCP 450 E-H AC
8. Check that the
9. Clean the level
correct position.
retaining clamps
and remove the
upper section of
the cleaner from
the dirt tank.
Lay the upper
section of the
cleaner down
with the filter
element facing
upwards. Do not
place the upper
section of the
cleaner on the
guard (1) and do
not damage the
filter element.
handle (2) and
remove it.
holder (3).
tective filter bag
over the filter
element.
the filter element
and close the
protective filter
bag with a knot.
seal (4). Check it
for damage and
replace it if
necessary.
control flap (6)
for filter cleaning
works properly.
The control flap
should move
back and for-
wards easily.
hose (7).
17