Results - Dräger Alcotest 5000 Gebrauchsanweisung

4.4

Results

After 2 to 7 seconds (depending on the measured concentration and
the instrument temperature) the test result is shown in the display and
stored in the instrument. Two kinds of results are possible:
C
27.12.2016
C) No alcohol detected. The test is passed. Additionally, the green LED
is lit. After 2 sec. the instrument will be ready for use again.
D) Alcohol detected. The test is failed. Additionally, the red LED is lit.
Press OK to proceed with the next measurement.
During the sensor recovery time the display shows a rotating

process symbol.
Repeat the procedure (see page 11 section "Performing the

measurement").
In the menu you can configure the confirmation of the test results
Alcohol and No alcohol as follows:
Confirm the test results by pressing OK

or
the test results are being confirmed automatically after 2 sec.

10:25 #00075
Intended use
D
27.12.2016 10:25
en
#00075
00633785
12