Troubleshooting; Declaration Of Conformity - auna Stealthbar-50 Handbuch

Tuning in a Station
• Tune in radio stations automatically: Press and hold the
automatically until a station is found. Note: The search may not stop at a station with a very weak signal.
• Tune in radio stations manually: Press the
Note: If reception is still poor, try to move the radio to another location.
Presetting Stations Manually
You can store up to 20 of your favourite stations to the memory. This will enable you to access your favourite sta-
tions quickly and easily.
1. Tune in the desired station, then press the PROG button.
2. Press the buttons to select the preset number.
3. Press the PROG button to store the station.
4. Repeat above steps 1 to 3 for each station you want to store in memory with a preset number.
Problem
No power
Remote control does not
work
No response from the unit
Disposal and Declaration of Conformity
According to the European waste regulation 2002/96/EG this symbol on the product or on its
packaging indicates that this product may not be treated as household waste. Instead it should
be taken to the appropriate collection point for the recycling of electrical and electronic equip-
ment. By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailled information about recycling
of this product, please contact your local council or your household waste disposial service.
Your product contains batteries covered by the European Directive. 2006/66/EG, which cannot
be disposed of with normal household waste. Please check local rules on separate collection of batteries. The cor-
rect disposal of batteries helps prevent potentially negative consequences on the environment and human health.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)

Troubleshooting

Solution
Ensure that the AC cord of the apparatus is properly connected .
Ensure that the unit is switched on.
Before you press any button, fi rst select the correct source.
- Reduce the distance between the remote control and the unit.
- Insert the battery with its polarities (+/-) aligned as indicated.
- Replace the battery.
- Aim the remote control directly at the sensor on the front of the unit.
Disconnect and reconnect the AC power plug, then turn the unit on again.
buttons, the frequency changes down or up
buttons repeatedly until you fi nd the station you want.
21