Remote Control - auna Stealthbar-50 Handbuch

1 Switch the unit between ON and STANDBY
mode.
2 SOURCE: Switch the modes.
3 SCAN: Scan for radio station in either
DAB+ or FM modes.
4 MUTE: Mute or resume the sound.
5 VOL+/- Increase or decrease volume level.
6 EQ: Select a preset sound effect.
7 Skip to previous/next track
in BT mode. Search for a radio station
(FM). Navigate to select an item on a
menu screen (DAB+). Select the secon-
dary station (DAB+).
station. /OK In BT mode, start or pause
playback. Confirm the selection on a menu
screen.
8 MENU: Display menu screen.
9 INFO: View information of FM/DAB+ ra-
dio stations.
10 PAIR: Activate the pairing function in BT
mode and disconnect the existing paired
BT device..
11 PROG: Presets radio stations.
12 DIM: Adjust display brightness
Prepare the Remote Control
Even if the Remote Control is operated within the effective range (6m), remote control
operation may be impossible if there are any obstacles between the unit and the remote
control. If the Remote Control is operated near other products which generate infrared
rays, or if other remote control devices using infra-red rays are used near the unit, it may
operate incorrectly. Conversely, the other products may operate incorrectly. The unit has
a pre-installed lithium CR2025 battery. Remove the protective tab to activate the battery.
Replace the Remote Control Battery
1. Pull out the battery tray and remove the old battery.
2. Avoid touching top/bottom of the battery or it may impair performance.
3. Place a new CR2025 battery into the battery tray with correct polarity (+/-) as indicated.
4. Insert the battery tray back into the slot.

Remote Control

Select a preset
15