Installation And Connections - auna Stealthbar-50 Handbuch

Connect the DAB+ Antenna
• Connect the supplied DAB+ antenna to the DAB+ socket on the rear of the unit by turning the antenna's screw
cap clockwise. Do not over tighten as this could damage the antenna.
• To avoid noisy interference, keep the antenna away from the unit, the connecting cord and the power cord.
• You may need to reposition the aerial for optimum reception.
• The best position is dependent on the station and the strength of the signal.
Use the OPTICAL Socket
• Remove the protective cap of the OPTICAL socket, then connect an OPTICAL cable (not included) to the TV's
OPTICAL OUT socket and the OPTICAL socket on the unit.
• Tip: If there is no sound come out of the soundbar and display shows „PLEASE CHANGE YOUR SOURCE DEVICE
TO PCM MODE UNDER AUDIO OUTPUT SETTING". Make sure the audio setting of your source player (e.g. DVD
player, game player, TV) is set to PCM with optical input.
Use the AUX Socket
• Use an audio cable (RCA to RCA) to connect the TV's audio output sockets to the AUX socket of the unit.
• Use an audio cable (3.5mm to RCA) to connect the TV's headphone socket to the AUX (input) socket of the unit.

Installation and Connections

16