Bluetooth Operation; Radio Operation - auna Stealthbar-50 Handbuch

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

You can listen to music from a BT-enabled device via this player. The first time you connect your BT device to this

player, you need to pair your device to this player.

Pair BT-enabled Device

• The operational range between this player and a BT device is approximately 8 meters (without any object bet-

ween the BT device and the unit).

• Before you connect a BT device to this unit, ensure you know the device's capabilities.

• Compatibility with all BT devices is not guaranteed.

• Any obstacle between this unit and a BT device can reduce the operational range.

• If the signal strength is weak, your BT receiver may disconnect, but it will re-enter pairing mode automatically.

Connecting devices via BT

• During ON mode, press the

tedly to select BT mode. "NO BT" will show on the display if the unit is not paired to any BT device.

• Activate your BT device and select the search mode.

• The unit will appear on your BT device list.

• Select the unit in the pairing list.

• Display panel show "BLUET" while the pairing succeeds.

Tips

• Enter „0000" for the password if necessary.

• If there is an existing connection, press the PAIR button on the remote control or press and hold

ton on the main unit to re-activate the pairing mode, the existing connection will be interrupted.

• If no other BT device pairs with this player within two minutes, the player will recover its previous connection.

• The player will also be disconnected when your device is moved beyond the operational range.

• If you want to reconnect your device to this player, place it within the operational range.

• If the device is moved beyond the operational range, when it is brought back, please check if the device is still

connected to the player. If the connection is lost, display panel shows "NO BT". Follow the instructions above

to pair your device to the player again.

Listen to Music from BT Device

• Pair your device with the player.

• Play music via your device (if it supports A2DP).

• Use supplied remote control to control play (if it supports AVRCP). To pause/resume play, press the

To skip to a track, press the

Auto Scan and Save Preset Station

• Press the

button repeatedly on the unit or press the SOURCE button repeatedly on the remote control to

select FM mode.

• Press the SCAN button on the remote control to activate automatic programming. All available stations are

programmed in the order of waveband reception strength.

• The first programed radio station is played automatically.

• To tune to a Preset Radio Station press the

the OK butter to confirm.