Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connect Power
• Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the ra-
ting label on the back or the underside of the unit.
• Before connecting the AC power cord, ensure you have
completed all other connections.
• Be sure to unplug the power cord from the outlet when
the system is not in use for an extended period of time.
• Connect the AC power cord to the AC~ socket on this
unit and to the wall socket.
Standby/ON
• When you first connect the unit to the mains socket, the unit will be in STANDBY mode.
• Press the
button to switch the unit ON.
• Press the
buttonto switch the unit back to STANDBY mode.
• Disconnect the mains plug from the mains socket if you want to switch the unit OFF completely.
Selecting Modes
• Press the
button repeatedly on the unit or press the SOURCE button repeatedly on the remote control to
switch between AUX/OPTICAL/BT/DAB+/FM modes.
• Note: If there is no signal under the AUX, OPTICAL and BT mode, the unit will automatically enter the standby
state within 15 minutes.
Adjusting Volume Level
• Press the VOL +/– button to adjust the volume.
• Press the MUTE button to mute the sound. Press this button again or press the VOL +/- to cancel the effect.
Selecting the Equaliser
• Press EQ on the remote control repeatedly to select a desired music mode (TV, MUSIC, MOVIE).
• When AUX or OPTICAL mode is selected, the equalizer will be set to MOVIE.
• When DAB+, FM or BT mode is selected, the equalizer will be set to MUSIC.
Adjusting Display Brightness
Press the DIM button repeatedly to select different levels of display brightness.
DAB+ / FM System Reset
There may be times when you need to reset your unit back to the factory settings especially when you have moved
house. If you experience reception problems you may want to reset and try again. If you move to another part of
the country and pick up the local and national DAB+/FM stations in that area, your previously tuned channels may
no longer be available.
1.
Press the SOURCE button to select FM or DAB+ mode.
2. Press the MENU button on the remote control, then press the
TEM". Press the OK button to confirm. The display shows „RESET".
3. Press the OK button, the display shows „RESET N". Then press the OK button to cancel OR Press the
buttons to select „RESET Y" and press the OK button to confirm to reset. When the reset is complete, the unit
will start scanning for FM or DAB+ channels immediately.
4. Note: After the system reset, all the tuned stations, DAB+ and FM preset stations will be erased.

General Operation

button repeatedly to select „SYS-
17

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis